Any employee operating a radio must do the following:
Employees transmitting or acknowledging a radio communication must begin with the required identification. The identification must include the following in this order:
* For base or wayside stations:
* For mobile units:
If communication continues without interruption, repeat the identification every 15 minutes.
Short Identification
After making a positive identification for switching, classification, and similar operations within a yard, fixed and mobile units may use a short identification after the initial transmission and acknowledgment.
An employee who receives a transmission must repeat it to the person transmitting the message, except when the communication:
The employee transmitting must say, "Over" to the employee receiving the transmission when the communication is complete and a response is expected.
The employee transmitting must give the required identification and say, "Out" to the employee receiving the transmission when the communication is complete and no response is expected.
An employee who does not understand a radio communication or who receives a communication that is incomplete must not act upon the communication and must treat it as if it was not sent.
EXCEPTION: An employee who receives information that may affect the safety of employees or the public or cause damage to property must take the safe course. When necessary, stop movement until the communication is understood.
Radios in attended base stations or mobile units must be turned on to the appropriate channel with the volume loud enough to receive communications. Employees attending base stations or mobile units must acknowledge all transmissions directed to the station or unit.
An employee receiving a radio call must acknowledge the call immediately unless doing so would interfere with safety.
Employees must not use radio communication to avoid complying with any rule.
Emergency calls will begin with the words "Emergency," "Emergency," "Emergency." These calls will only be used to cover initial reports of derailments, collisions, storms, washouts, fires, track obstructions, property damage, or injury to employees or the public. Emergency calls must contain as much complete information on the incident as possible.
All employees must give absolute priority to an emergency communication. Unless they are answering or aiding the emergency call, employees must not send any communication until they are certain no interference will result.
Employees must not transmit a false emergency or an unnecessary or unidentified communication. Employees must not use indecent language over the radio. Employees must not reveal the existence, contents, or meaning of any communication (except emergency communications) to persons other than those it is intended for, or those whose duties may require knowing about it.
Employees must not use the radio to give information to a train or engine crew about the name, position, aspect, or indication displayed by a fixed signal, unless the information is given between members of the same crew or the information is needed to warn of an emergency.
When the radio is used instead of hand signals, information must include the direction and distance to be traveled.
Movement must stop within half of the distance specified unless additional instructions are received.
When transmitted by radio, track warrants and track bulletins must be transmitted according to applicable operating rules and the following:
If necessary, a phonetic alphabet (Alpha, Bravo, Charlie, etc.) will be used to pronounce clearly any letter used as an initial, except initial letters of railroads.
The railroad must authorize any radio transmitters used in railroad service. Radio transmitters must operate on frequencies the Federal Communications Commission assigns the railroad. Employees are prohibited from using other transmitters or railroad frequencies not assigned to that particular territory.
Radios used in train operation, outside of a yard, must be tested at the point where the train is originally made up.
Engineers and conductors must test the radios at least once during each tour of duty to verify the radios are working.
The radio test must include an exchange of voice transmissions with another radio. The test must confirm the quality of the radio's transmission.
Malfunctioning radios must not be used. As soon as possible, notify each crew member and the train dispatcher or other affected employees that the radio is not working.
Employees must not operate radio transmitters located less than 250 feet from blasting operations.
Employees are prohibited from making internal adjustments to a railroad radio unless they are specifically authorized by the FCC or hold a current Certified Technicians Certificate. Employees authorized to make adjustments must carry their FCC operator license, Certified Technicians Certificate, or verification card while on duty.
